1 Chin Pad (A)

 1 Clavicle Pad (B)

 2 Back Panel Pads (C)

 1 Secure Strap, length 18” (D)

 5 Round Hook and Loop Tabs (15mm) (E)

 5 Round Hook and Loop Tabs (20mm) (F)

For easier installation position the angle of the chin-rest to its highest setting. 

Fold the clavicle pad in half with the gray color on the outside, position the pad, and press firmly to ensure the pad stays in place. 

Position the neck pad, and press firmly to ensure the pad stays in place. 

Position the 2 back panel pads, there is an upper and a lower pad, press firmly to ensure the pads stay in place. 

The kit includes 10 total pcs of hook and loop tabs for replacement, replace as needed.

Before applying make sure the area is clean from any dirty or old adhesive residue.

Peel off the paper backing from the hook and loop tab.

Apply the hook and loop tab directly to the plastic collar, and press firmly to ensure the adhesive makes full contact.

Allow the adhesive to set for at least 30 minutes before use.

The kit includes a spare secure strap, replace if necessary. 

Loop the secure strap through either end of the back panel, there are slots on each end.

Extend the back panel to its tallest setting then loop the strap through the middle d-rings slots.

Loop the strap through the opposite end of the back panel, and adjust as necessary.